Advent ADV38 Guía de instalación

Installation GuideADV38” OVERHEAD LED BACKLITLCD MONITORWITH DVD PLAYER10.1ON OFF AUTO

CONNECTING THE DOME LIGHTSThe dome lights in the video monitor require three connections to the vehicle's wiring. There are twocommon types of do

Red / black - Lamp onTo 12 pinconnectorToconstantToconstantBlack / red - Lamp commonPurple / brown - Lamp AutoFactory Door ajarswitch or BodyControl c

© 2014 VOXX ELECTRONICS CORP., 150 Marcus Blvd. Hauppauge, NY 11788128-8513E

Important NoticeAn LCD panel and/or video monitor may be installed in a motor vehicle and visible to thedriver if the LCD panel or video monitor is us

MATERIALS INCLUDED IN THIS PACKAGE:1) 10.1 TFT LCD Overhead Monitor With DVD Player - (1pc)2) 12 Pin Power / Signal Harness (P/N 112-3483) - (1pc)3) 2

Begin by hooking area “A” (above) over the dome light and slide the cover over the pod. The cover will snap in place.Place the pod on a soft surface t

Work on a soft surface to avoid damaging the plastic.Insert the supplied between the Housing and , then press the to releasethe .pry tool Snap On Cove

VEHICLE PREPARATION:1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v whenkey is off), and also a good groun

TRIM RING INSTALLATION:Note:Note:This page only covers special installation considerations for thick trim ring installation. If the videomonitor is to

TRIM RING INSTALLATION:Supplied screws as below use for install Trim Ring to unit. Please refer illustration below.A) #4 x 5/16 Self Tapping Screws (1

91) Make the connections to the vehicle for the 12 pin wiring harness.2) Connect the 2 pin power harness to vehicle’s electrical system bytapping into