Advent ADV25 Guía de instalación descargar pdf (Pagina 7)

GENERAL SYSTEM CONFIGURATIONS:

The following is intended to provide some of the system configurations that are possible with the ADV25

Drop Down Video Systems:

The ADV25 has an option that allows the user to select from two IR transmit and receive codes (M1 or M2).

This feature can be used when using two ADV25s in the same installation or if the vehicle has an RSA

(Rear Seat Audio) that uses an “A” channel headset. The ADV25 comes factory set to M1. When in the M1

mode the unit will respond to remote commands when M1 is selected on the remote and will transmit audio

on the A channel. When in the M2 mode the unit will respond to remote commands when M2 is selected on

the remote and will transmit audio on the B channel.

Note: OSD will appear on the screen for 4~5 seconds

Selecting a Monitor Code (M1 or M2)

1. Press and hold the SOURCE and FMM buttons on the unit for 3 seconds and the unit will switch from M1 to

M2 or M2 to M1.

2. The selected mode (M1 or M2) will be retained in memory until changed by the user.

Notes:

There are a few options that can be added as follows:

a) Wired relay box for wireless FM Modulator (P/N SIRSWB).

b) Pod TVT2 TV Tuner.

The ADV25 video system is only intended for an overhead, drop down installation. It is not intended for

Seatback or any other type of mounting. The hinging mechanism is designed for horizontal, drop down

use only.

The two pods can be connected together using the 8010730 accessory cable plugged into the AV1 Din

connector on one pod and plugging the RCA connectors into the AV out RCA connectors on the other

pod. Two 8010730 cable can be used to allow the video program on each pod to be viewed on the other.

FMM OFF

DVD

IRT OFF

FMM 88.3MHz

AUX/GAME

IRT ON

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Sin comentarios

Advent ADV25 Guía de instalación Pagina 7