Advent LCD4WM Manual de usuario descargar pdf (Pagina 6)

bracket and flip the camera over so the picture will not be displayed up

side down.

9. Route the camera wiring into the vehicle. The wire can be run through

an existing grommet, behind a tail lamp, under the trunk molding, or

if necessary, through a 5/8 inch hole drilled near the vehicle’s rear

license plate. When choosing a wiring path, make sure the cable

will not be damaged or pinched, as this may cause a short circuit

that is not covered by the warranty. If drilling a hole, perform the

following steps:

a) Acquire a 5/8 inch drill bit, rust preventive, all of which can be

purchased at a hardware store.

b) Check behind the intended drilling location before drilling to

verify that no wires or mechanisms can interfere with or be

damaged during drilling.

c) Check for interference with license plate lights and the hatch

release switch and/or mechanism.

d) Drill a 5/8 inch hole at the selected location.

e) Coat the edge of the hole with rust preventative.

f) Route the camera cable through the grommet and then through

the hole.

g) Insert the grommet in the hole to keep water from entering the

vehicle.

Surface Mounting Instructions

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Advent LCD4WM Manual de usuario Pagina 6